Shelf Bracket — modelo 3D

Shelf Bracket

por JakeD en Thingiverse

I needed some shelves in my office, so I designed and printed some cool looking shelf brackets! This is a 3" angle, meant to be used with (2) screws into your shelf and (1) screw into your wall. Use a board 6" deep or less. The picture shown is a 5" deep board, 24" wide. The strength of your shelf..

Descargar los 2 archivos Ver en Thingiverse

2 archivos · 1,2 MB · se descargan uno tras otro

Licencia

Uso comercial permitido

CC BY 4.0 — Atribución

Puedes imprimirlo, modificarlo y venderlo dando crédito al autor.

Al descargar aceptas respetar la licencia y dar crédito a JakeD.

Archivos (2)

Categoría: Organización
Formatos: STL, 3DM
Descargas: 15,967
Publicado: 21 de febrero de 2015

Sobre este modelo

I needed some shelves in my office, so I designed and printed some cool looking shelf brackets! This is a 3" angle, meant to be used with (2) screws into your shelf and (1) screw into your wall. Use a board 6" deep or less. The picture shown is a 5" deep board, 24" wide. The strength of your shelf with depend mostly on your wall anchors. I recommend drilling into a stud OR using a 50lb wall anchor. Good luck!

Descripción original del autor, publicada en Thingiverse.

Más de Organización