Sheik - Zelda: Ocarina of Time | Desk/Ledge Sitter

Boost MeI put a lot of effort into testing and optimizing this model to ensure a clean finish. If this model prints perfectly for you, a Boost is greatly appreciated and helps me keep creating! 🚀 🎶 Sheik - Zelda: Ocarina of Time Navi already claimed a spot on my desk, so Sheik is taking the edge. Lyre in hand and legs hanging over the ledge, this little companion brings another piece of Hyrule to your workspace.

Inspired by Sheik from The Legend of Zelda: Ocarina of Time remake, this figurine has a flattened seat beneath the hips and upper thighs, shaped for displaying on a desk, shelf edge, or anything else you can think of. 🪑 A Little Hyrule on the Edge The seated pose lets Sheik rest on a suitable flat ledge with the legs hanging freely below.

Choose a surface wide enough to support the entire flattened seat, with clearance behind the legs. Check that the figure rests securely before leaving it in place.

Designed around broad desk and shelf edges. Fit and balance on narrow or curved monitor tops have not been confirmed. 🖨️ Printing Notes The included profile is prepared for a detailed single-color FDM print, with the figure and lyre printed together.

- ✓ Saved variable layer heights use finer layers where the curved details benefit.

- ✓ Print orientation and Tree Slim supports are included.

- ✓ General infill is set to 10%.

- ✓ A denser region around the hips adds weight near the seat.

Open the 3MF as a project to retain the included settings, modifiers, orientation, and variable layer heights. Check the sliced preview with your selected printer and filament before printing.

I added a density modifier to give more weight to the back of the model so it doesn't tip over so please don't remove this when printing. ✂️ Support Removal The hair, fingers, and lyre details need a gentle touch during cleanup.

Let the print cool completely, then clip the support branches into smaller sections. Support the nearby detail with your fingers while removing each contact point rather than pulling away a large support tree at once.

Take extra care around the thin lyre strings and ends of the braids. 🌈 Want a Multicolor Version? Would you like a multicolor print profile for Sheik? Let me know in the comments! If there’s enough interest from the community, I’ll work on preparing one. Your feedback helps me decide what to make next. 📸 Share Your Print I’d love to see where Sheik ends up sitting beside your gaming setup, on a bookshelf, or keeping Navi company.

Share your filament choices, painted versions, and little Zelda display setups! Likes, follows, boosts, and photos of your prints are always appreciated and help support future projects. 💚 🟢 More Zelda Prints If you like this print, check out my other Zelda props and collectibles below:

Zelda Props & Collectibles Collection (Click the image):

If you enjoy my models and want to support future projects, you can buy me a coffee here. Thanks for the support!