Self-Draining Wave Soap Dish with Drip Spout
por shellylee3d en Thangs
A bar soap dish that drains itself. Your soap stays dry and firm and does not sit in a puddle of slime. Six raised wavy ribs hold the bar 8 mm above the floor, so air gets underneath. The floor slopes 1.7 mm toward one end. Water runs between the ribs to a 26 mm wide drain slot and out over a short
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalSin licencia indicada
El autor no indicó una licencia: todos los derechos le pertenecen. Úsalo solo para imprimir en casa y consulta al autor para cualquier otro uso.
Al descargar aceptas respetar la licencia y dar crédito a shellylee3d.
Archivos (1)
- assembled.stl STL · 1,7 MB
- Categoría
- Jardín
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
A bar soap dish that drains itself. Your soap stays dry and firm and does not sit in a puddle of slime. Six raised wavy ribs hold the bar 8 mm above the floor, so air gets underneath. The floor slopes 1.7 mm toward one end. Water runs between the ribs to a 26 mm wide drain slot and out over a short drip spout. Set the spout over the sink edge and the water drips straight into the basin. Two crossing channels on the underside leave four corner feet, so it will not stick to a wet counter. Two warm sand wave ribbons run around the outside wall, printed in as a second color and flush with the surface. No text or logo anywhere. Fits bar soaps up to about 110 x 75 mm. Size 125.9 x 84.8 x 22.0 mm including the spout. Print settings: PLA, 0.20 mm Standard profile, no supports, about 2h 1m and 58.6 g. Colors: seafoam aqua 5FBFAE body and warm sand E8D9BE inlay. PETG is recommended for a wet bathroom and warm water.
Descripción original del autor, publicada en Thangs.
