Self Balancing Bird
por Juan Cuervas en Thingiverse
Still not sure whether it works or not? Check this YouTube video then: https://youtube.com/shorts/54BiBE97o5k A self balancing bird toy I designed as an experiment, which turned out to work perfectly after a few iterations. It was sculpted using zbrush and refined using Blender. If you have...
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Juan Cuervas.
Archivos (1)
- Categoría
- Para tu impresora
- Formatos
- STL
- Descargas
- 29,494
- Publicado
Sobre este modelo
Still not sure whether it works or not? Check this YouTube video then: https://youtube.com/shorts/54BiBE97o5k A self balancing bird toy I designed as an experiment, which turned out to work perfectly after a few iterations. It was sculpted using zbrush and refined using Blender. If you have troubles printing it, check out my YouTube video about it! https://youtu.be/MDfjgsP0VXQ It works even when it's 1cm/ 0,39in in width: https://youtube.com/shorts/w8_KZAmZRkU PRINT SETTINGS - These were mine, but are not the rule. Feel free to change them depending on your needs :) Layer height: 0.16mm Print speed: 60mm/s Wall speed: 30mm/s Infill: 20% Supports: Everywhere, overhang angle 53º Build plate adhesion: Brim Let me know in the comments if you have printed it!
Descripción original del autor, publicada en Thingiverse.
