Seeed Studio X1 Meshtastic / Lora tracker
por tawr en Printables
Just a simple slipon case for the x1. I realized I forgot to make the notch for the lanyard, but you can clip it easily
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo sin pedir permiso ni dar crédito.
Al descargar aceptas respetar la licencia y dar crédito a tawr.
Archivos (1)
- Categoría
- Tecnología
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
Just a quick slip on case for the X1 tracker. I realized after printing that I didn't make the cutout notch for the lanyard, but since it doesn't really do any work, clipping a single leg between 2 cells front and back is enough to let the lanyard go through, and hold the case onto the device snugly. I'm not sure why it came out so thick but it could be reduced in thickness by a few mm. Picture below is it printed with no top/bottom layers, only walls and hex infil pattern which I think came out quite nice
Descripción original del autor, publicada en Printables.
