Screwdriver bit holder – 1/4" hex, labelled, customisable
por scotti cad en Thingiverse
A block that holds 1/4" hex screwdriver bits upright, with each pocket labelled: slotted, hex, Torx, Phillips and Pozidriv, 24 in all. - A small lead-in round each pocket, so bits drop in easily - A hole through the bottom of each pocket, to push out a stuck bit - Prints as it sits, with no...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a scotti cad.
- Categoría
- Herramientas
- Formatos
- 3MF, STL, ZIP
- Descargas
- 3
- Publicado
Sobre este modelo
A block that holds 1/4" hex screwdriver bits upright, with each pocket labelled: slotted, hex, Torx, Phillips and Pozidriv, 24 in all. - A small lead-in round each pocket, so bits drop in easily - A hole through the bottom of each pocket, to push out a stuck bit - Prints as it sits, with no supports
Make your own version! I designed this in ScottiCAD, a free, open-source 3D modeller for Windows and Linux. The holder is built by a short script, bit-holder.star. Every size is a named number at the top, and the layout comes from a list of labels. Add, remove or rename bits and the block resizes itself to fit. If your bits are tight, raise FIT a little. To run the script: open ScottiCAD, click Scripting, paste it into the Editor tab and press F5. Or open bit-holder.scotticad to use the design as it is. The design and the script are also on GitHub.
Descripción original del autor, publicada en Thingiverse.
