Screaming Ghost LED Tealight Holder – Halloween Lantern, Arms Up, No Supports
por MarsupiolMakes en Cults3D
Set this little ghost over an LED tealight and it greets everyone with a scream: arms up, eyes wide and the light flickering out of its open mouth. It looks like the ceramic ghost lanterns you find in Halloween shops, but it prints in one piece, standing up, with no supports.
Cults3D entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalLicencia de uso privado de Cults3D: puedes imprimirlo para ti. No se permite compartir el archivo ni vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a MarsupiolMakes.
Archivos (1)
- fantasma_portavela.stl STL
- Categoría
- Hogar
- Formatos
- STL
- Descargas
- 1
- Publicado
Sobre este modelo
Set this little ghost over an LED tealight and it greets everyone with a scream: arms up, eyes wide and the light flickering out of its open mouth. It looks like the ceramic ghost lanterns you find in Halloween shops, but it prints in one piece, standing up, with no supports.
WHY YOU'LL LIKE IT
- Just put it on top: the ghost is open at the bottom, so it covers any 38 mm LED tealight (up to 43 mm wide). Lift it to switch the candle on or off.
- The big oval mouth is the window: the tunnel slopes down towards the candle, so you see the flame and the glow from the front.
- Cute and spooky at the same time: chunky raised arms, round eyes and a wavy sheet hem.
- Prints standing in one go: the roof inside is a cone and every overhang is angled, so there is nothing to support or clean up.
WHAT'S INCLUDED
- 1 STL file: ghost tealight holder, 77 × 68 × 88 mm.
- Original design.
#cultsoween
Descripción original del autor, publicada en Cults3D.
