Scooter Lock Slide on Winder
por Cubz en MakerWorld
This is a specialty Scooter Lock Slide on Winder. This project was created to solve the problem of losing scooter locks. This model safely attaches the lock through a minimalist winding system. It can easily be tightened or loosened. Also, 100% 3D printed.
MakerWorld entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalStandard Digital File License
Licencia estándar de archivos digitales: solo uso personal. No se permite compartir, revender ni subir el archivo a otros sitios, ni vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Cubz.
- Categoría
- Jardín
- Descargas
- 0
- Publicado
Sobre este modelo
This is a specialty Scooter Lock Slide on Winder.
This project was created to solve the problem of losing scooter locks. This model safely attaches the lock through a minimalist winding system. It can easily be tightened or loosened. Also, 100% 3D printed.
I used the Razor Flashback Scooter as my demonstration. However, most standard scooters should work.
I also used an 8mm wide scooter lock.
I created some cool TPU logos if you want to glue them on too.
Instructions for usage:
- Print all parts
- Remove tree supports with pliers
- They may be stuck on pretty firm but can be taken 100% off with patience
- Slide the inner ring into the outer ring
- This may take a couple goes. If you are struggling try to twist it in.
- Once it fits in, and the inner slides smoothly align the holes
- Remove the handlebar from the scooter and slide in the winder
- Then, insert the lock in and twist the outside to tighten
- Twist the other way to loosen
Boost MeQ: What is a 3D printer's absolute favorite movie?
A: The Fast and the Layer-est.
Descripción original del autor, publicada en MakerWorld.
