scalable locking ring
por Jonathan Jones en Thingiverse
flipped the latch to be vertical so no supports needed, simplified the latch so it prints well at smaller sizes. basic 3D printing optimizations that should've been done by the original author size is same as original, but again this one can be scaled with much less issue printing this with 100%...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Jonathan Jones.
- Categoría
- Herramientas
- Formatos
- STL, 3MF
- Descargas
- 1
- Publicado
Sobre este modelo
flipped the latch to be vertical so no supports needed, simplified the latch so it prints well at smaller sizes. basic 3D printing optimizations that should've been done by the original author size is same as original, but again this one can be scaled with much less issue printing this with 100% infill recommended
Descripción original del autor, publicada en Thingiverse.
