Satsana Ender 3 Fan Duct for CR-Touch
por e30andrew en Printables
This is a modified remix of the Satsana Fan Shroud/Duct by eric-anastas for the Ender 3 Pro with CR-Touch
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo sin pedir permiso ni dar crédito.
Al descargar aceptas respetar la licencia y dar crédito a e30andrew.
- Categoría
- Para tu impresora
- Formatos
- STL
- Descargas
- 1,583
- Publicado
Sobre este modelo
This is a modified remix of the Satsana Fan Shroud/Duct by eric-anastas for the Ender 3 Pro. This shroud is modified to fit with the Creality CR-Touch touch sensor, using the standard hardware that comes with it.
Printing:
Take note of the printing picture above. You will need to use a block object to prevent support generation on overlap, so that the bottom connecting sections will be supported only.
I printed this at .16 layer height, but im sure .2 would do just fine.
Print Settings
Printer Brand:
Creality
Printer: Ender 3 Pro
Rafts:
No
Supports: Yes
Resolution:
200
Infill: 38
Filament: Overture PLA Post-Printing =============
Post Printing - using an exacto blade or razor to remove the supports from the connecting sections seen in the image below. This will allow room for the Cr-Touch bracket to install properly.
Category: 3D Printer Accessories
Descripción original del autor, publicada en Printables.
