Sata Connector Cover
por anastmag en Printables
Sata Connector Cover Replacement
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a anastmag.
Archivos (2)
- Categoría
- Tecnología
- Formatos
- 3MF, GCODE
- Descargas
- 0
- Publicado
Sobre este modelo
During the repair of a flat ribbon cable for a sata connector of a minipc, I noticed that the cover was broken in more than two pieces and I was missing at least one. So I designed the cover based on measurements. In the rare case that this may be useful to somebody, I'm publishing it here. Printed in PLA with a 0.25mm nozzle on my MK3S. It's not that sturdy but I don't plan to remove it from the connector and it works. It is slightly thicker than the original to make it stronger.
Descripción original del autor, publicada en Printables.
