Ryobi P117 Battery Charger Wall Mount
por John Kimzey en Thingiverse
I bought a replacement battery charger but found that the model was designed to put on a shelf and not wall mount. Simple enough fix. I designed a small "shelf" with pegs to hold the charger in place and then a slanted wall mount for mounting to the wall at a working angle. I printed this using PLA.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a John Kimzey.
Archivos (2)
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
I bought a replacement battery charger but found that the model was designed to put on a shelf and not wall mount. Simple enough fix. I designed a small "shelf" with pegs to hold the charger in place and then a slanted wall mount for mounting to the wall at a working angle. I printed this using PLA with a .2 mm line height and .7mm line width, 15% infill and tree supports enabled.
Descripción original del autor, publicada en Thingiverse.
