Rounded safe cubicle hook for 2 inch cubical walls
por Jason Burke en Thingiverse
This design for a 2in cubicle wall hook is rounded on both sides of the hook to prevent any potential injuries that could occur by falling into or rubbing against the hook. In addition, all the edges are chamfered and fillet to make it so it has no sharp edges. This hook is printed on its side with.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Jason Burke.
Archivos (1)
- Categoría
- Hogar
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
This design for a 2in cubicle wall hook is rounded on both sides of the hook to prevent any potential injuries that could occur by falling into or rubbing against the hook. In addition, all the edges are chamfered and fillet to make it so it has no sharp edges. This hook is printed on its side with no supports. Around 20% infill should be sufficient. To install the hook, angle it over the top of the cubical wall such that the internal ridges can pop over the top of the cubical wall.
Descripción original del autor, publicada en Thingiverse.
