Round Welding Goggles with flip up lenses
por Kaliber6 en Thingiverse
I added a hinge with a second lens holder. The hinge slides between the cap and the main body of the goggles (5 mm gap). The additional lens holder is connected to the hinge through a 6 mm hole. You can 3D print "roll.stl" and use it as the hinge pin, or use a screw or something similar. If your...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Kaliber6.
Archivos (5)
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 11
- Publicado
Sobre este modelo
I added a hinge with a second lens holder. The hinge slides between the cap and the main body of the goggles (5 mm gap). The additional lens holder is connected to the hinge through a 6 mm hole. You can 3D print "roll.stl" and use it as the hinge pin, or use a screw or something similar. If your hinge has low friction you can use insulating tape to hold it better or print "hinge block add-on.stl" and put it on the hinge. It has a tooth which should stop the hinge in open and closed position.
Descripción original del autor, publicada en Thingiverse.
