Round Storage Tin with Screw Lid – Ø 130 mm Inside, Free Box for Cookie Cutter Sets

Round storage tin with a screw-on lid – free, 130 mm inside.

This is the tin we use for all our nesting cookie cutter sets. The lid now screws on instead of just sitting on top, so nothing falls out when you carry it or stack it in the drawer. The cutters from our sets fit inside as before; you can of course use it for anything else that fits – sprinkles, piping tips, buttons, small parts.

The thread has 0.3 mm play on each side, so it should turn without force on a normal printer. Both parts print flat without supports: the tin on its floor, the lid on its top face.

• Inside Ø 130 mm, 31.5 mm deep

• Tin Ø 136 mm, height 33.5 mm

• Lid Ø 141 mm – closed height about 36 mm

• 2 STL files (tin + lid)

Fits all S3D cookie cutter sets with our standard tin (not the larger fluted pastry set).

How it was made: design and sizes are ours; pictures and checking of the files were done with Claude Code (AI). It's free – if you print it, we'd love to see a make.

Our cookie cutter sets and baking tools: https://cults3d.com/en/design-collections/S3D/cookie-cutters-baking-tools-nesting-sets-rings-kitchen-helpers

Runde Aufbewahrungsdose mit Schraubdeckel – kostenlos, innen Ø 130 mm.

Das ist die Dose zu unseren Ausstecher-Sets, jetzt mit Schraubdeckel statt Stülpdeckel – da fällt nichts mehr raus. Die Ausstecher aus unseren Sets passen wie bisher hinein, sonst passt alles rein, was Platz hat (Streusel, Tüllen, Kleinteile).

• Innen Ø 130 mm, 31,5 mm tief

• Dose Ø 136 mm, Höhe 33,5 mm; Deckel Ø 141 mm, zu ca. 36 mm hoch

• 2 STL-Dateien, druckbar ohne Stützen, 0,3 mm Spiel am Gewinde

Design und Maße von uns, Bilder und Dateiprüfung mit Claude Code (KI). Kostenlos – über Makes freuen wir uns.