RGB headphone stand
por Jacob Wright en Thingiverse
Remix of headphone stand by MakerBot and dual colour headphone stand by Octimusocti. https://www.thingiverse.com/thing:3610580 I printed mine at 109% to allow for a 20cm rigid aRGB strip. If you're fitting a flexible or shorter strip then regular scale will be fine. Octimusocti put in a 0.2mm...
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a Jacob Wright.
- Categoría
- Organización
- Formatos
- STL
- Descargas
- 3,954
- Publicado
Sobre este modelo
Remix of headphone stand by MakerBot and dual colour headphone stand by Octimusocti. https://www.thingiverse.com/thing:3610580 I printed mine at 109% to allow for a 20cm rigid aRGB strip. If you're fitting a flexible or shorter strip then regular scale will be fine. Octimusocti put in a 0.2mm clearance to the insert but I found I had to print it 1% lower (108% in my case) to fit.
Descripción original del autor, publicada en Thingiverse.
