Retro Single Can Picnic Cooler
Sup bros and brahs! Back at-cha with a new cooler design! Need to chill a cold one at a picnic? Got the perfect thing for you! A single can cooler with handles!
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Revisa las condiciones11111111111.png
El autor usa su propia licencia. Revisa sus condiciones en la página original antes de compartir, modificar o vender.
Al descargar aceptas respetar la licencia y dar crédito a Corey M.
Archivos (6)
- Picnic Can Cooler Body.STL STL · 1,8 MB
- Picnic Can Cooler Handle 01.STL STL · 521 KB
- Picnic Can Cooler Handle 02.STL STL · 521 KB
- Picnic Can Cooler Insulation.STL STL · 166 KB
- Picnic Can Cooler Lid.STL STL · 888 KB
- Picnic Can Cooler.STEP STEP · 6,0 MB
- Categoría
- Jardín
- Formatos
- STL, STEP
- Descargas
- 397
- Publicado
Sobre este modelo
Sup bros and brahs! Back at-cha with a new cooler design! Need to chill a cold one at a picnic? Got the perfect thing for you! A single can cooler with handles!
Was really inspired by LayerOne3d's single can cooler, check his work out here: https://social.thangs.com/u/110590
Print Settings The Body, and Insulation can be printed without supports. I printed them out at 20% infill with 4 perimeters/shells and it felt rigid.
The Handle needs to be printed flat with supports on the snap detail. I printed this at 20% infill as well.
The Lid can be printed with the top laying down on the print bed but may need supports on the edges. I printed this at 20% infill as well.
Assembly
The Insulation slides into the Body and is pressure fit together, use super glue if needed.
The Handles can snap into the Body after they are cleaned of supports. Make sure that the handles fit together to form an "A-frame" at the center before snapping them in.
The lid will pressure fit into the cooler.
Hope you find this print to be fly!
Let me know if you have any questions or suggestions!
Descripción original del autor, publicada en Thangs.
