![[REMIX] Clip stick and Base — modelo 3D](https://r2.centro3d.com/m/aa94486ff8c84aee2141eff0/1280.webp)
[REMIX] Clip stick and Base
por Christopher O en Thangs
The clip stick is used to clamp the model, while the base provides support, allowing for drying at various angles, spray painting, repairs, and other tasks.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Christopher O.
Archivos (2)
- base-Christech.stl STL · 128 KB
- clipstick-Christech.stl STL · 62 KB
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 71
- Publicado
Sobre este modelo
The clip stick is used to clamp the model, while the base provides support, allowing for drying at various angles, spray painting, repairs, and other tasks.
Suitable for both beginners and experienced users, it supports various models for spray painting, positioning, air drying, repairs, and electronic motherboard welding.
Clip stick size: About 68mm Base dimension: 46mm (width) x 100mm (height)
Suggested print settings: No supports are needed but follow the suggested print orientation for ideal results.
Remix Original: Simple clothespin (fully 3d printed) of the original "(https://makerworld.com/en/models/843346-simple-clothespin-fully-3d-printed#profileId-789998)" by "@Steezy (https://makerworld.com/en/@Steezy)" from MakerWorld.
More designs on Printables: https://www.printables.com/@ChrisTech Linkedin: https://www.linkedin.com/in/christopherong81/ Buy me a coffee: https://buymeacoffee.com/chrisong
Descripción original del autor, publicada en Thangs.
