Rekon 7 Modifications

What’s included - Electronics cover: side covers and a top lid that enclose the flight stack. Tested in mild rain.

- Camera mounting options: mounts for different camera setups.

- GPS top plate modification: a mount designed for the ARK M10 GPS, sitting on the top plate.

Built around - Rekon 7 frame

- ARK FPV flight controller (30.5 × 30.5 mm)

- ARK M10 GPS

Print recommendations - Covers and mounts: Everything was designed to be printed with ASA

- Walls: at least 3 perimeters on the covers for water resistance.

- Supports: as needed depending on orientation.

Notes - Rain-resistant, not waterproof. Conformal-coat your electronics for extra protection. The print should also be vapor smoothed to help with water proofing.

- Make sure your VTX gets airflow if it’s mounted inside the cover. This was designed for winter conditions; it will most likely overheat if you don't have the same conditions.

- Not affiliated with Rekon or ARK Electronics.

Specs - Frame: Rekon 7 (7")

- Flight controller: ARK FPV running PX4. 30.5mm standard mounting pattern, supporting a 3-12s battery input with a regulated 12V 2A output for video transmitters and payloads. px4

- ESC: Hobbywing 4-in-1 (30.5 × 30.5 mm)

- Motors: iFlight XING2 2809 1250KV.

- Props: 7"

- VTX: Foxeer Reaper Extreme.

- FPV camera: Foxeer T-Rex Micro

- VTX antenna: TrueRC, RHCP

- GPS: ARK M10

- Optical flow: ARK Flow LR (DroneCAN)

Still to Come - ARK Optical Flow mounting

- Improved ARK M10 GPS mounting

- Improved Camera Mounting