Reinforced bookstand
por Thoro en Printables
I modified this out of another model that had trouble keeping itself upright and staying apart.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Thoro.
- Categoría
- Hogar
- Formatos
- STL
- Descargas
- 1
- Publicado
Sobre este modelo
This is a remix of another model i tried to print for myself, but had issues with it. (It wanted to tip over and bend when i put some books on it) I added legs to keep it upright and reinforced it on the wall side so the books weight won't bend it so easily anymore, the result is less pretty, but more robust version of the same thing. Now that i think of it, this could be a lot prettier if the legs were less tall, but this works so i'm not gonna use more filament to update and test it further.
Print it sideways as shown on the picture so the layer end up vertically when its used.
Print one of each sides version or just one if you don't need both.
Supports are not needed.
Descripción original del autor, publicada en Printables.
