RC Catamaran V5!
por StuNZ en Printables
Big improvements since version 4 - 86 km/h on a 4S battery!
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a StuNZ.
Archivos (36)
- Bow Reinforcement.stl STL · 41 KB
- Clamp End Tool.stl STL · 128 KB
- Hull Transom.stl STL · 127 KB
- Hull Stern.stl STL · 1,9 MB
- Hull Middle Aft.stl STL · 2,5 MB
- Hull Middle Front.stl STL · 1,3 MB
- Hull Bow.stl STL · 992 KB
- Lid Back.stl STL · 620 KB
- Lid Front.stl STL · 1,1 MB
- Strut Mount.stl STL · 74 KB
- Strut Mount Thin.stl STL · 74 KB
- Motor Mount Port.stl STL · 100 KB
- Motor Mount Starboard.stl STL · 100 KB
- Motor Mount Face.stl STL · 165 KB
- Stand Aft.stl STL · 51 KB
- Stand Forward.stl STL · 71 KB
- Transom - No Holes.stl STL · 24 KB
- Middle Back - No Holes.stl STL · 2,3 MB
- Stern - No Holes.stl STL · 1,8 MB
- Strut Mount.gcode GCODE · 1,4 MB
- Motor Mounts.gcode GCODE · 5,2 MB
- Hull Transom.gcode GCODE · 4,1 MB
- Hull Stern.gcode GCODE · 18,8 MB
- Hull Middle Aft.gcode GCODE · 20,6 MB
- Hull Middle Fwd.gcode GCODE · 15,4 MB
- Hull Bow.gcode GCODE · 10,8 MB
- Bow Reinforcement.gcode GCODE · 549 KB
- Lid.gcode GCODE · 22,4 MB
- Clamp End.gcode GCODE · 1,1 MB
- Stand Forward.gcode GCODE · 2,0 MB
- Stand Aft.gcode GCODE · 1,9 MB
- Transom - No Holes.gcode GCODE · 3,5 MB
- Stern - No Holes.gcode GCODE · 16,4 MB
- Middle Back - No Hole.gcode GCODE · 18,5 MB
- TPU Gasket Aft.gcode GCODE · 406 KB
- TPU Gasket Front.gcode GCODE · 386 KB
- Categoría
- Varios
- Formatos
- STL, GCODE
- Descargas
- 1
- Publicado
Sobre este modelo
The STL files include holes and are set up for the parts in the parts list so use these if you plan to use the same motor and rudder setup as I did. Otherwise use the alternative STL files in the "No holes" folder if you want to glue in your own motor mount and set things up differently. Using my set up I managed to reach 86 km/h on a single 4S LiPo battery! The seal for the lid is optional and I printed mine using TPU. The gcode files are the same files I used with my Ender V3 SE. Please let me know if you have any questions! Build video coming soon...
Descripción original del autor, publicada en Printables.
