Raspberry Pi 7 Inch Touchscreen display case
por Luc Eeckelaert en Thingiverse
Easy to print solid Raspberry Pi 2 or 3, Official 7 inch touchscreen case. I wanted to keep the black bezel look of the screen and not making it bigger. You will need 4 M3x6 or 8 screws to secure the back cover. There is room inside for the power cables. I will use this as a kiosk display and NAS...
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Luc Eeckelaert.
Archivos (14)
- Raspi7inch_Front.stl STL · 2,5 MB
- Raspi7inch_Case.stl STL · 2,6 MB
- Raspi7inch_Lid_Velcro_1cm_HDD_Rest.stl STL · 1,6 MB
- Raspi7inch_Lid_Velcro_2cm_HDD_Rest.stl STL · 1,6 MB
- Raspi7inch_Lid.stl STL · 1,6 MB
- Raspi7inch_Case_SD_Access.stl STL · 2,6 MB
- Raspi7inch_SD_Hatch.stl STL · 275 KB
- Raspi7inch_Front_Split_Left.stl STL · 1,3 MB
- Raspi7inch_Front_Split_Right.stl STL · 1,3 MB
- Raspi7inch_Split_Left_Case_SD_Access.stl STL · 246 KB
- Raspi7inch_Split_Right_Case_SD_Access.stl STL · 251 KB
- Raspi7inch_Case_SD_Access.123dx 123DX · 132 KB
- Raspi7inch_Lid.123dx 123DX · 95 KB
- Raspi7inch_Front.123dx 123DX · 89 KB
- Categoría
- Tecnología
- Formatos
- STL, 123DX
- Descargas (todas las plataformas)
- 58,764
- Publicado
También en
Sobre este modelo
Easy to print solid Raspberry Pi 2 or 3, Official 7 inch touchscreen case. I wanted to keep the black bezel look of the screen and not making it bigger. You will need 4 M3x6 or 8 screws to secure the back cover. There is room inside for the power cables. I will use this as a kiosk display and NAS for my Kodi player I have cut out some areas at the back where I can add velcro strips to mount a 2.5 inch HDD. Enjoy and show off your builds and mods. Update 290516: Added 2cm Velcro lid and lid without HDD support. Update 310516: Added new case with little door access to the SD card. Still need small pliers or pincet but it's easier than unscrewing the back lid. Update 150317: Added split STL for front to enable print on small print beds. Update 010118: Added split STL for case Left and Right to enable print on small print beds Update 240418: Added the 123Design source files
Descripción original del autor, publicada en Thingiverse.
