Raspberry Pi 4B case
por PassiveLemon en Thangs
Note: Tolerances are VERY tight, screws are not required to snap the Pi into place. You do not need any other equipment.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Uso comercial permitidoPuedes usarlo, modificarlo y venderlo; si distribuyes versiones modificadas deben ir con la misma licencia y sus fuentes.
Al descargar aceptas respetar la licencia y dar crédito a PassiveLemon.
Archivos (2)
- PiCaseBottom6-Fillet.stl STL · 236 KB
- PiCaseTop6-Fillet.stl STL · 267 KB
- Categoría
- Para tu impresora
- Formatos
- STL
- Descargas
- 208
- Publicado
Sobre este modelo
Note: Tolerances are VERY tight, screws are not required to snap the Pi into place. You do not need any other equipment.
Once the Pi is set, you can snap the lid into place. It is recommended to put the SD card in after the Pi is set in the base just to make installation much easier.
The screw holes are 1.3 mm diameter.
This is my first 3D model, any feedback is appreciated!
Descripción original del autor, publicada en Thangs.
