RadioMaster Pocket Nano Module Bay Cover

Lost or broke the module bay cover on your RadioMaster Pocket? This is a replacement modeled from scratch to match the original part, inside and out. - Slides onto the bay rails like the stock cover and locks firmly in place. - Inside detail copied from the original: top lip, corner bars with hooks, side T-posts and the center latch plate. Hollow inside, so nothing touches the module pins. - Prints face-down: the outer face gets the textured PEI finish, with only 0.1 g of support under the beveled end. Print settings (tested on a Bambu Lab P1S, 0.4 nozzle): PLA, face-down, textured PEI plate, Arachne wall generator, normal supports on build plate only. About 16 min and 3 g. Fit: the rails fit perfectly. Locking it needs a firm push, which is what keeps it secure. If yours comes out too tight, scale X to 100.5 %. Started as a fit test with Rob's "Radiomaster Pocket spiky stick ends with storage" cover (thanks, Rob!). This is a new design drawn from scratch from measurements of the original part. --- ¿Perdiste o rompiste la tapa de la bahía del módulo de tu RadioMaster Pocket? Réplica dibujada desde cero, igual a la original por fuera y por dentro. Entra por los rieles como la de fábrica y queda bien asegurada; es hueca por dentro y no toca los pines. Se imprime boca abajo (cara de fuera en la placa PEI texturizada), PLA, Arachne, soportes solo desde la placa: unos 16 min y 3 g.