Quest 3 DAS Deluxe Audio strap adapters

This design allows for rotating the headstrap up to allow easy on/off of the headset. I also added a lower support to prevent the headset from pressing on my cheeks. Tilt the Quest 3 sidearms up a bit until you have almost no pressure on cheeks and most all pressure on forehead for a similar feel to a halo strap. Print the side arm adapters on their side standing up on long horizontal edge for minimal amount of support to remove. Print the headstrap adapter vertically with longer side on the vertical. I did use some other designs in my design but I don't really remember which. I used Tinkercad to combine pieces of some of my previous designs along with other Quest 3 designs. You will need to heat up the inside of the sidearm adapters with a hair dryer for around 35-40 seconds (for PLA) to be able to mold them to the Quest 3 sidearms.