Qidi Plus 4 - Lid and Extra Bed Holder
A Simple Holder for the Qidi Plus 4 Lid and Bed. It is shown on the side of the printer but could be mounted on any flat surface. The back corner spaces the Bed to match the indent in the lid, but you could just use all rails. This used one corner in the back and four rails.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalSin licencia indicada
El autor no indicó una licencia: todos los derechos le pertenecen. Úsalo solo para imprimir en casa y consulta al autor para cualquier otro uso.
Al descargar aceptas respetar la licencia y dar crédito a Nathan T.
Archivos (5)
- Lid and Bed Holder - Back Corner.stl STL · 171 KB
- Lid and Bed Holder - Rail Bottom.stl STL · 137 KB
- Lid and Bed Holder - Rail Side.stl STL · 168 KB
- Lid and Bed Holder - Rail Bottom.stl STL
- Lid and Bed Holder - Rail Side.stl STL
- Categoría
- Para tu impresora
- Formatos
- STL
- Descargas
- 91
- Publicado
Sobre este modelo
A Simple Holder for the Qidi Plus 4 Lid and Bed. It is shown on the side of the printer but could be mounted on any flat surface. The back corner spaces the Bed to match the indent in the lid, but you could just use all rails. This used one corner in the back and four rails.
Vertical risers where added for better tape adhesion on the bottom rail. You should print two of these. I mounted it with Gorilla two-sided tape, and it is holding well so far.
It is printed in PLA with the default profile. It is just a quick design, but it has worked well enough I wanted to share it.
Descripción original del autor, publicada en Thangs.
