Punisher Skull Logo Magnet
por Marcin Mączewski en Printables
You can glue a 10 x 1.5 mm round magnet in the base.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Marcin Mączewski.
- Categoría
- Figuras y arte
- Formatos
- STL, GCODE
- Descargas
- 977
- Publicado
Sobre este modelo
You can glue a 10 x 1.5 mm round magnet in the base.
Print instructions Recommended infill angle: 0°
Low speed and high temperature will create a shiny top surface.
There are "holes" inside the model to make some of the top layers more uniform, and they were created with 0.2 layer height in mind.
If your top surface is not flat & shiny and you see scarring, then make sure to check this guide: https://bit.ly/2UtN0I1
Descripción original del autor, publicada en Printables.
