Punisher Foregrip AR15
por Stonecold en Printables
I modeled the Punisher Skull and added it to the Short 2 IPT file in this source.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Stonecold.
- Categoría
- Jardín
- Formatos
- STL
- Descargas
- 4,126
- Publicado
Sobre este modelo
I modeled the Punisher Skull and added it to the Short 2 IPT file in this source. https://www.thingiverse.com/thing:580466
I found this one https://www.thingiverse.com/thing:2742432 on here, But my slicer didn't like it so I made one. I didn't use this one for anything but the design Idea.
I added a .2 tall sections across the slit in the rail slot to help bridging in those areas, you will need to remove these after printing as they are only there to help reduce the need for supports. See the picture with the red circled areas.
- Update 2/7/2020 :
It was brought to my attention that not all rails are alike, so I extended the original file from 76.7mm to 79.7mm center to center between mounting holes to accommodate the difference.
Short_2_punisher 2 - has 76.7mm center to center holes
Short_2_punisher 80mm - has 79.7mm center to center holes
Print instructions Category: Toy & Game Accessories Print Settings
Printer Brand: Prusa
Printer: i3 MK3S
Rafts: Doesn't Matter
Supports: Doesn't Matter
Resolution: .2
Infill: 30%+
Filament: Filament One PLA Glint Silver
Notes:
I just printed this in PLA as a test print, I'd suggest a minimum PTEG
Descripción original del autor, publicada en Printables.
