PS3 and EX90 Dual Magsafe v2
por AHolyDuck en Printables
This is a 3d print with 2 mounts for Apple Magsafe(25watt/Braided cable) That goes over the existing Charging pad.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a AHolyDuck.
Archivos (1)
- Categoría
- Repuestos
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
My Polestar 3 will still read my NFC key off my Fold 8 on the left hand side.
I printed mine with Fuzzy skin making sure to not make the inside of the charging puck area Fuzzy. Feels a little loose in the charging tray without a phone attached, but with my Fold 8 on the left or my wifes Iphone on the right it is pretty sturdy and does not move around much.
To print this i suggest panting the outside of the print with Fuzzy skin, it seems to help with Fitment a little bit. You will need to print with Supports , I left mine on defaults after enabling(Tree Auto, Default, 30 and remove small overhangs)
Printed in ASA because it sits in the car.
You will need 2 Apple magsafe pucks i used 2 of the newer 25watt ones but from the original model v1 should also work.
This will overlap your volume wheel a little bit but in my experience it is still usable with a Fold 8 upside down or a Iphone 18 pro.
Descripción original del autor, publicada en Printables.
