Prusa MK4 LED Status Bar Extension
por Big Dutch en Printables
Small fitting for LED Status Bar for Prusa MK4 if LCD Panel hangs off of a table
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Big Dutch.
Archivos (1)
- Categoría
- Para tu impresora
- Formatos
- STL
- Descargas
- 1,696
- Publicado
Sobre este modelo
My printers sit on an ikea Kallax shelf which causes the LCD panel to hang over. Since the new MK4 has an awesome LED Status Bar, I did not want to lose out on the feature.
Model printed without supports and misses LED and any chips on board. It is my first go at designing an upgrade for 3d printers even though I have used them for years. Hope it helps someone. I may try it later with different infills to see how it diffuses the light.
Printed in clear Colorfabb XT Co-polyester on MK4 with stock settings for printer and filament.
Descripción original del autor, publicada en Printables.
