Prusa HT Hotend Nozzle Change Tool

I designed a sock to be able to keep the HT hotend everytime even for standard filament, so the next thing to make was a tool to be able to easily change the nozzle. This accessory secures the HT hotend firmly in place. It allows for rapid nozzle changes with minimal risk of bending the nozzle tube or damaging heater/thermistor. This one is made for standard flow nozzle. PRINT TIPS - print settings: 0.20mm, 3 perimeters, 15% gyroid infill

- print material: I suggest PETG or any higher filament

TOOLS - Uni-wrench or HEX 7mm socket

INSTALLATION - Unload the filament from the Nextruder.

- Make sure that the heaterblock is clean.

- Remove the sock if you have one.

- Carefully align the CORE One (L) tool with the hotend's heater block.

- Gently slide the Nozzle ChangeTool onto the heater block

- Loosen both thumbs screws securing the hotend inside the Nextruder. Do not remove them completely. A few turns are enough.

- Now, you can easily release the nozzle.

COMMENTS WARNING: Ensure the printer is completely cooled to ambient temperature before beginning installation. Attempting to install the Nozzle Replacement Tool on a hot printer can result in serious injury due to burns. CAUTION: After replacing the nozzle, do not forget to tighten both thumb screws securing the hotend in the Nextruder! SUPPORT ME! If you want to support me, don't hesitate to like and download the files so I can earn some prusameters or consider using my referal code when buying a printer: @ScottWolfs :) If you really want to help, you can join my CLUB!