Printer Poop Dice Mold
por StitchKing en Printables
Great way to reuse that annoying printer poop!
Licencia
Solo uso personalStandard Digital File License
Licencia estándar de archivos digitales: solo uso personal. No se permite compartir, revender ni subir el archivo a otros sitios, ni vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a StitchKing.
- Categoría
- Figuras y arte
- Formatos
- 3MF, STL
- Descargas
- 1,224
- Publicado
Sobre este modelo
It's recommended to use 8.5～8.6g of PLA. After the molten plastic is placed into the mold, apply pressure for 15 seconds, let it sit for 1 minute, and then apply pressure again for another 15 seconds.]
This is a mold for making dice by recycling 3D printing waste (PLA).The mold, printed using PETG (PETG-CF is a preferred alternative), can recycle approximately 8.8g of PLA at a time. Required Tools: - Oven
- 3M respirator
- Silicone baking tray
- One G-clamp
- One M2 10mm screw (used as an ejector pin)
- Flathead screwdriver
- Hammer
Manufacturing Process: - Place 8.8 grams of PLA in the oven and heat at 210°C for about 8 minutes.
- Use the G-clamp to secure the mold tightly.
- Pour the melted plastic into the mold, insert the plunger, and press or step on it with firm pressure (about 15 seconds).
- Allow the mold to cool for approximately 5 minutes, then open the mold and use the M2 screw as an ejector to remove the dice.
- Remove any rough edges and sand the dice for a smooth finish.
Descripción original del autor, publicada en Printables.
