Print in Place Steam Deck Joystick Guard
My take on a joystick guard which would allow you to safely put the deck in a backpack without a carrycase.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a Maaz A.
Archivos (5)
- Guard (low tolerance).stl STL · 3,9 MB
- Guard.step STEP · 100 KB
- Guard.stl STL · 3,8 MB
- Guard(v48).stl STL · 3,8 MB
- Steam Deck Joystick Guard v48.f3d F3D
- Categoría
- Tecnología
- Formatos
- STL, STEP, F3D
- Descargas
- 288
- Publicado
Sobre este modelo
My take on a joystick guard which would allow you to safely put the deck in a backpack without a carrycase.
The most consistent way I got it to print well is to slice upside down (bigger side on top). This allows for better support placement on the hinge.
Another tip Is to not take the print off the bed immediately, Instead heat the bed to the glass transition temperature of your filament (80-85c for PET-G And 55-60c for PLA). Once it has been heated for a while, remove the part while still warm and then slowly attempt to close/open the hinge. This will make the two halves open more easily while also not snapping.
Magnets used: 5x3mm (https://www.amazon.com/Magnets-Neodymium-Magnet-Whiteboard-Kitchen/dp/B09GLWMN7N/ref=sr_1_4?crid=1J2K0A9MGQQRU&keywords=5x3+magnets&qid=1677016998&sprefix=5x3+ma%2Caps%2C100&sr=8-4)
Descripción original del autor, publicada en Thangs.
