Presta Valve Cap
por PouOu en Printables
Wanted a cap that sat a little firmer on, as they tend to fall off, or crack when you try to make them sit well.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a PouOu.
Archivos (5)
- Categoría
- Jardín
- Formatos
- 3MF, STL, GCODE
- Descargas
- 2,895
- Publicado
Sobre este modelo
Wanted a cap that sat a little firmer on, as they tend to fall off, or crack when you try to make them sit well. Recommends printing with maximum 0.1 layer height. Printing multiple at once is no problem. Remember dry filament. You might have to scale it up just a litle bit,depending on your printer. 1-5%. I also included a g-code / 3MF with 9 pcs. This can of course be changed easily! :-) Let me know if there are any problems. Print instructions Layer height <0.10
Descripción original del autor, publicada en Printables.
