Porsche 944 tow hitch

As-is no liability and no official tow rating! Fits my early 1985 944 NA; I think it'll fit 86+, might fit 924? I took a laser scan of the back of my car and designed this weldment. I believe this ties into the car the same as the factory hitch however I can't find any actual photos of one to confirm. No modifications needed to the car. The holes for the forward mounting bolts are already there and just have rubber plugs in them. You might need to dig into the undercoating a bit to find them. Designed to be laser cut and CNC bent from somewhere like Send Cut Send. My order came to $351. You'll need two receiver_gussets and one of everything else. Everything is 0.188" HRPO A36/1008 mild steel except for receiver_rear_plate which I got in 0.250". You'll also need: - Generic weld-on 1.25" receiver tube https://www.amazon.com/dp/B0087PAATQ

- 2x2" 3' 0.188" wall steel tube (needs to be trimmed to ~90cm) https://www.mcmaster.com/6527K514/

- M8x1.25 30mm bolts https://www.mcmaster.com/93474A218/

- Large M8 washers https://www.mcmaster.com/91116A160/

- M12 bolts https://www.mcmaster.com/90386A118/

- M12 nuts https://www.mcmaster.com/94645A230/

- Large M12 washers https://www.mcmaster.com/94630A114/

- Paint (I had mine powder coated by a local guy for $100)

- Welder, grinder/bandsaw, etc.

- Brain and basic fab experience

If you want the raw scan of the back of my car reach out and I can share it. It's a bit too big to upload here.