Porsche 914 2.0 FI throttle body to plenum gasket
por NARP-parts en Thingiverse
This is a reproduction of the gasket that seals the bottom side of the throttle body to the top side of the plenum on a fuel injected 1973 Porsche 914 2.0. I was unable to find print settings that did not result in an air leak, but the shape appears to be correct. Feedback is greatly appreciated...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a NARP-parts.
- Categoría
- Repuestos
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
This is a reproduction of the gasket that seals the bottom side of the throttle body to the top side of the plenum on a fuel injected 1973 Porsche 914 2.0. I was unable to find print settings that did not result in an air leak, but the shape appears to be correct. Feedback is greatly appreciated. At the least, you could print a few layers and use it as a template to cut your own gasket from proper material. Hope this helps someone!
Descripción original del autor, publicada en Thingiverse.
