Polaris Fuel Pump Retaining Ring Wrench - Ranger ETX plus Others
por Derek Tombrello en MyMiniFactory
This wrench is designed to specifically fit a 2016 Polaris Ranger ETX, but I am sure it will fit many other models and, possibly, makes. It is designed to fit a 200x200mm bed and assembled using either superglue or, my preference - Weld-On/SCIGRIP 16 Cement.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Derek Tombrello.
Archivos (2)
- Categoría
- Moda y joyería
- Formatos
- STL
- Descargas
- 120
- Publicado
Sobre este modelo
This wrench is designed to specifically fit a 2016 Polaris Ranger ETX, but I am sure it will fit many other models and, possibly, makes. It is designed to fit a 200x200mm bed and assembled using either superglue or, my preference - Weld-On/SCIGRIP 16 Cement.
For best results, print in the orientation presented at 0.2 to 0.3mm layer height with 40-70% triangular infill (I overdo everything so I went with 70%) and supports enabled touching build plate only. Supports may or may not be needed, depending on your printer, but they are easy to remove and don't use much filament at all so I just went with it. Your mileage may vary. The letters were filled in with lightly thinned, white Plaid FolkArt Multi-Surface Acrylic paint.
Descripción original del autor, publicada en MyMiniFactory.
