Pokeball V1
I had been wanting to make a Pokeball with my printer for a while, and although I had initially thought of using one of the existing models, this time I wanted to make the model from scratch. I was inspired by several of the existing models on the internet and I share the result I got to.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Revisa las condicionesPokeball V1
El autor usa su propia licencia. Revisa sus condiciones en la página original antes de compartir, modificar o vender.
Al descargar aceptas respetar la licencia y dar crédito a Gonzalo H.
Archivos (8)
- Bottom Inn.stl STL · 3,5 MB
- Bottom Out.stl STL · 482 KB
- Button.stl STL · 278 KB
- Energy Bottom.stl STL · 414 KB
- Energy Top.stl STL · 315 KB
- Top Inn.stl STL · 1,4 MB
- Top Pokeball Out.stl STL · 482 KB
- Base.stl STL · 979 KB
- Categoría
- Cosplay y props
- Formatos
- STL
- Descargas
- 282
- Publicado
Sobre este modelo
I had been wanting to make a Pokeball with my printer for a while, and although I had initially thought of using one of the existing models, this time I wanted to make the model from scratch. I was inspired by several of the existing models on the internet and I share the result I got to.
I must clarify that this model is not completely printed, it needs two 3mm x 1.5mm magnets to operate the button and an 8mm barrel hinge to join the upper part with the lower part. I have used the following: - Hinge (https://s.click.aliexpress.com/e/_DlqvpDx) - Magnets (https://s.click.aliexpress.com/e/_DElivEH)
I recommend printing the outer parts with a 0.1mm layer height. The model is designed so as not to have to paint practically any part (although I have had to).
I really hope you enjoy this model. I also include a base for the exposition of the Pokeball. Happy printing!
Descripción original del autor, publicada en Thangs.
