Pocket Fingerboard
por OCÚN en Printables
Small gadget, big ambitions. A pocket-sized fingerboard for single-finger training and pre-climb warm-ups.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a OCÚN.
Archivos (3)
- Categoría
- Jardín
- Formatos
- STEP, 3MF, STL
- Descargas
- 2
- Publicado
Sobre este modelo
Waiting for the bus? Bored on your commute? Give your fingers something to do. This pocket-sized fingerboard is easy to take along for a little training between climbing sessions or a gentle warm-up at the crag. Use Attach the fingerboard using a cord up to 6 mm in diameter. Place one finger in the pocket and apply a controlled pull. Start gently and increase resistance gradually. Printing settings PETG is recommended for its toughness and resistance to impact. - Material: PETG
- Layer height: 0.2 mm
- Infill: 15%
- Supports: No
- Brim: No
- Perimeters: 5 for increased strength
- Orientation: Print with the chamfered edge facing down.
Let’s engineer together! Print it, take it climbing, and let us know how it works for you. Share your makes, feedback, and ideas to help us improve it. Engineered for climbing. Let’s engineer together. *Safety note: This model is an accessory, not personal protective equipment (PPE). Do not use it for belaying or fall protection.
Descripción original del autor, publicada en Printables.
