Pliers Hanger_Remix.3mf

I needed a sturdy and accessible way to organize my pliers on the MultiBoard wall system, so I remixed the excellent original design by @MSThings, which was originally made for IKEA Skådis.

This version is fully compatible with MultiBoard, using 2-directional snap mounts for a secure hold without screws or extra hardware.

🛠 Features:

Holds 6+ pliers comfortably Clean and angled design for easy access Directional snap-fit system (no tools needed) Prints in one piece (no supports required) 📦 Printing Tips:

Material: PLA Layer Height: 0.2 mm Printed on a Bambu Lab X1C 🔧 Recommended Tools & Materials The following are affiliate links. If you make a purchase through them, I may earn a small commission at no additional cost to you. Thank you for supporting my work!

🧵 PLA Matte Filament for Sharp Surface Finish: Overture Matte PLA – Various Colors (Amazon) (https://amzn.to/4lZ7kJG) Polymaker Matte PLA - Various Colors (Amazon) (https://amzn.to/4eULNiM)

💡 Whether you're organizing your electronics bench or workshop, this remix brings a clean, modular upgrade to your MultiBoard system.

Big thanks again to @MSThings for the original design!

License and Attribution: This remix is shared under the same license as the original model: Keep Making Remix License Attribution: Snap component remixed from Multiboard Designer on Thangs Rights granted to Keep Making: non-exclusive, royalty-free, non-transferable, sub-licensable, worldwide, irrevocable license to use and modify this design