Plastic Buckle (Designed for 3d printing with zero supports)
por Rasmus H. en Thingiverse
V2 with 2x the Strength: https://www.thingiverse.com/thing:6848458 Plastic Buckle design with the FDM 3d printing method in mind: 1. No support needed 2. Prints in only 30 minutes. This is version 5 of a plastic replacement buckle that I designed with the FDM 3d printing process in mind: No support.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Rasmus H..
Archivos (3)
- Categoría
- Tecnología
- Formatos
- STL
- Descargas
- 13,885
- Publicado
Sobre este modelo
V2 with 2x the Strength: https://www.thingiverse.com/thing:6848458 Plastic Buckle design with the FDM 3d printing method in mind: 1. No support needed 2. Prints in only 30 minutes. This is version 5 of a plastic replacement buckle that I designed with the FDM 3d printing process in mind: No support is needed Prints in only 30 minutes Optimized print orientation for strength Designed to counter possible elephants's foot The outside dimensions of the model can be seen in the picture below The holes are 6mm x 11mm
Descripción original del autor, publicada en Thingiverse.
