Planter (Pine Mountain Water Fall) Self-Watering

Planter with water fall, catch pool and self watering system. Fill the bowl at the bottom with sand. Water your plant and excess water travels into soil, out side tunnels and down the waterfall, then into the bottom pool where it's directed from the pool back into the sand bowl where it wicks back up into the soil. You can also plant sprouts or moss in the pool. Self Watering system: Fill the oval hollow bowl at the very bottom of the planter (depicted in blue see image) with sand or a permeable substrate. Then, fill the remaining area up to the top of the planter. There are 5 drain holes, 3 down the center of the waterfall, 1 on each side inside the caves, along with the 4 shoots coming out of the rock face into the reservoir pool. Water can travel in two tunnels skirting around both sides of the model or a tube at the bottom of the pool, back to the bowl filled with sand. You will see this when you slice the model. I made this for my mom so she doesn't have to water all the time. Enjoy! Let me know if you have any improvement advise. I love to hear what people think and how I can improve. Always looking for good ideas. Best Print Settings I use a 6mm Nozzle so adjust for .04 mm .27 to .30 Layer Width .62 LH Infill 17% ZigZag for the bottom 1.25 inches then 14% Grid for the remaining model (The last image depicts the Support Blocker Mask that shows where to use 17% ZigZag) 2 Walls (Can use 1 but I prefer 2 walls) Do Not use supports or overhang settings. Not needed. If you print with make over hangs printable it will remove the self-watering tunnels.