Planetary Gear Tape Holder

About This Model: This model was made for a Hackclub project and also for personal and practical use for everyone to use! This was a design made for a simple and initiative approach to the CAD experience as a CAD amateur. A semi-complex, triple planetary-gear system composed of different gears and parts to hold some tape rolls! 3 sets of planetary gear-boxes connected together to hold tape rolls. This can be considered more of a fidget, but it does serve a function. This 3D model can hold 3 small tape rolls, few, but intended for a test design for a future coming, improved model! Take in mind this model was created as a prototype and first out come of a further, larger coming project involving gears! Fits on most printer beds and total size is up to 8.625 in. wide Printing and Assembly: All parts designed for simple, straightforward, 3D printing set up. Lay parts by flattest face to bed. Assembly image provided in model page. (Parts go on top and connected to each other as shown exploded within image!) Arranging as slicing software recommended or so may be the best option. To assemble: REQUIRED!: 3mm thread screws of varied lengths for multiple parts such as alternates for pin, and necessary for assembling join pieces together Put together the three planetary gear boxes along with the tape holders. Finally, put everything together with tri-joint pieces and 3mm screws | Gears: Print flat. | Pin Alternate: 3mm D x 30mm L metal pin for stronger structure. | Other: This project will be continued in the future for improvement and an even more complex system of mechanical parts. For anyone downloading this, thank you for the support!