Pixel Garden - Swap-Head Pixel Flowers (No AMS)

Five retro pixel flowers, one swap system - designed for printers WITHOUT AMS. Every plate is exactly one colour, so any single-nozzle printer can make the whole set: load the matching filament for each plate and just press print. No AMS, no mid-print filament swaps, no supports, no glue. SWAP-HEAD DESIGN Each flower head mounts on a T-slot: slide it into the stem from the back and it locks - you can lift the whole flower by its head and it won't pull off. To change flowers, push the head backward and slide in another one. One hand is enough. WHAT'S INCLUDED (10 PLATES) Plate 1 = Flower pot (terracotta) Plate 2 = Stem & leaves (green) Plate 3 = Tulip head + rose center (red) Plate 4 = Sunflower head + daisy center (yellow) Plate 5 = Daisy head (white) Plate 6 = Rose head (pink) Plate 7 = Lavender head (purple) Plate 8 = Sunflower center (dark brown) Plate 9 = 3-slot window tray (optional) Plate 10 = Assembly preview (do NOT print) PRINTING Any PLA, 0.2 mm layers, about 15% infill, no supports needed. The pot and the tray are oriented upside-down on purpose, so every wall is vertical with zero overhangs. All clearances are 0.15 mm per side, test-fitted on a Bambu A1 mini and a P1P. ASSEMBLY Step 1: press the flower centers into their pockets from the front (they sit 0.4 mm proud for a 3D look). Step 2: slide a flower head's T-foot into the stem channel from the back, all the way down. Step 3: push the stem's pin into the pot's pocket. Done - swap heads whenever you like. 100% original pixel art. More flowers and a vase are coming in the Pixel Garden series - follow for updates! 【五款復古像素花・免 AMS・一盤一色】每一盤都只有一個顏色：換上對應色的線材、按下列印就好。不用 AMS、不用中途換線、免支撐、免黏膠。 【可換頭設計】花頭用 T 槽卡榫固定：從莖的背面滑入就鎖住，抓著花頭把整支花提起來也不會脱落；想換花，把花頭往後推滑出、再滑入另一顆，單手就能操作。 【列印】任何 PLA、層高 0.2 mm、填充 15%、全程免支撐；花盆與擺盤刻意倒放列印（零懸空）。間隙 0.15 mm/側，已在 A1 mini 與 P1P 實印驗證。 【組裝】花心從正面壓入（凸 0.4 mm 立體感）→ 花頭 T 腳從莖背面滑入到底 → 莖插入花盆。盤 10 是組裝示意，請勿列印。全部原創像素圖，像素花園系列會持續推出新花款與花瓶，歡迎追蹤！