PivotDock – Sink Organizer with Swivel Arms

Update – New self-draining tray for PivotDock

You can now choose between the original drip tray and a self-draining version. The new tray slopes toward the front, guiding water through the spout directly into your sink.

____________________________________________________________________________________________________________________

PivotDock gives your dishcloths and sponge a place to dry beside the kitchen sink. Hang a dishcloth over a swivel arm and rest the sponge on the removable grate. Water collects in the drip tray underneath. Choose the single-arm version for one dishcloth or the dual-arm version for two. On either version, you can swing an arm over the sink to let a wet cloth drip or move it aside to reach the sponge. On the dual-arm version, the arms swivel independently, so you can spread two cloths apart to dry. Dimensions Both versions have the same overall dimensions: 240 × 155 × 242 mm (W × D × H). Each arm has approx. 195 mm of usable length, excluding the raised tip. Arm height (measured to the top edge)Above countertopAbove grate Single-arm version213 mm193 mm Dual-arm version · upper arm213 mm193 mm Dual-arm version · lower arm175 mm155 mm

Printing A print profile is included for each version. Both print well in PLA or PETG. The parts print separately, so you can combine colors without an AMS. Only the thread at the bottom of the post needs a small amount of support. All other parts print support-free. PartsWallsGyroid infill Base and removable grate210% Spacer ring (dual-arm version only)210% Swivel arm(s), post and end cap315%

To remove the supports from the thread at the bottom of the post, twist them clockwise.

Assembly

- Print the parts for your chosen version and remove the supports from the thread at the bottom of the post.

- Slide the parts onto the post from the top, with the raised arm tips pointing up. Single-arm version — slide on the arm. Dual-arm version — slide on the lower arm, then the spacer ring, then the upper arm.

- Screw the end cap onto the top of the post.

- Screw the assembled post into the base using the printed thread.

- Place the removable grate into the drip tray.

Boost MeThank you for your support! :)