Phone & Tablet Stand 60° with Cable Slot

A solid, low-profile stand for your phone or small tablet that charges while it stands. The backrest sits at 60° (easy reading and video calls), and the charging cable goes in from below: a Ø12 mm hole under the port, a notch in the front lip and a V-groove under the base lead the cable out to the front, so the stand sits flat and never rocks on the cable.

- Two sizes: 76 mm wide for phones (up to ~75 mm wide, e.g. Pro Max in a case) and 100 mm wide for small tablets / e-readers (up to ~13 mm thick in a case).

- Front lip holds devices up to 16 mm thick (phone in a thick case, tablet in a cover) and stops them from sliding forward.

- Cable path: Ø12 mm hole in the base under the charging port, 22 mm notch in the lip, and a 9 × 4.5 mm V-groove underneath (fits cables up to ~3.7 mm; USB-C and Lightning plugs pass through the hole).

- Stable: the base reaches back under the top of the backrest, so the stand does not tip back when you tap the screen.

- Prints in its natural position, no supports: the backrest leans only 30° from vertical, everything else is a plain profile. Rounded corners, no sharp edges.

Print settings

- Orientation: as supplied (base flat on the plate). No supports, no brim.

- 0.20 mm layer, 3 walls, 15% infill. PLA or PETG.

- Time on Bambu Lab A1, PLA, 0.20 mm: 76 mm – 1 h 06 min / 31.4 g; 100 mm – 1 h 30 min / 51.8 g.

Tip: put the device on the base, lean it on the backrest, and plug the cable from below through the hole. Designed from scratch by bezbajzlu.