Pegboard Paper Towel Holder | Easy On & Off!
por qquarter25 en MakerWorld
I disliked how some models required you to put the paper towel on the holder THEN onto the pegboard (and vice versa to replace). I needed a pegboard paper towel holder that was extremely practical - i.e. super easy & fast to remove and replace.
MakerWorld entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalMakerWorld Exclusive License
Licencia exclusiva de la plataforma: uso personal, no se permite compartir el archivo ni vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a qquarter25.
- Categoría
- Hogar
- Descargas
- 0
- Publicado
Sobre este modelo
I disliked how some models required you to put the paper towel on the holder THEN onto the pegboard (and vice versa to replace). I needed a pegboard paper towel holder that was extremely practical - i.e. super easy & fast to remove and replace.
So I designed one with a bit of wiggle-room to be able to push the holders to the side just enough to remove & replace a new paper towel without completely removing the holders from the pegboard. The 3x2 pegs make it very sturdy & stable and very hard to fall off accidentally with normal use. I mainly designed it for Scott blue paper towels but should work for any normal kind.
Pegboard Compatibility: 1 inch Recommended Filament: Any
Recommended [PLA] Slicer Settings:
- Layer Height: 0.2mm
- Wall Generator: Arachne
- Wall Loops: 3
- Infill: Any pattern; 5-15%
- Supports Needed! I used: - Tree (auto); default
- Initial/First layer expansion = 1mm
- Everything else can be default support settings, but I left my customized support settings in the 3mf if you would like to try them =)
Descripción original del autor, publicada en MakerWorld.
