Party glasses - 2024

A model of funny glasses for celebrating the arrival of the new year 2024. Printing: Print takes a little over 2 hours and I reccomend to use color-change during print, e.g. first 3 layers with one color and rest with black color. But of course you can go without color-change as well. - Use PLA to bend the front part well in hot water. - Use brim for the temples. - Custom supports are ready for the revolute joint of the temples and work well for 0,2mm layerheight.

Post processing: Also see images here https://www.printables.com/model/342945-party-glasses-2023. - Remove temple brims and clean the edges. - Bend the front frame a bit using hot water (or heat gun) and coffee saucer. Hot tap water was sufficient in my case. - Remove small support block from the temples (inside joint). - Try to insert piece of filament into the holes. The holes may probably need to be enlarged. - Slide the temples onto the frame and insert the filament. - Trim the end of the filament. - Enjoy the party ;)

Also check out: https://www.youtube.com/channel/UChKp-968z1i5PN29gbR7YfA https://www.cgtrader.com/rorys3d