Panda Breath HEPA filter latch (for Snapmaker U1) - Better cover retention and compatibility

This is a functional remix of the Panda Breath HEPA filter latch for Snapmaker U1 by anti. It adjusts the geometry to hold the BIQU Panda Breath filter cover much more securely while providing better clearance for alternative mounting brackets. Key Improvements - Stronger Cover Retention: Tightens up the fit so the filter cover stays firmly locked in place. Not that you would, but you could shake the thing and it won't come loose, yet it is still quick and easy to remove.

- Better Mount Compatibility: Adjusted clearance to work seamlessly with alternative Snapmaker U1 Panda Breath mounts (and their remixes), such as: https://www.printables.com/model/1654577-panda-breath-heater-mount-for-snapmaker-u1

- Easy Maintenance: Allows you to quickly access and swap the filter without having to slide the cover off or unmount the entire Panda Breath unit.

Installation Tip For the latch side, don't tighten the screws all the way down until you have pushed the latch over the cover 2 to 3 mm. Then, push the parts with the screw holes toward each other (and toward the latch) as you tighten those screws down. This will help the latch move more positively and align properly. How It Was Made This remix was created entirely using slicer-side Boolean operations (combining positive primitives and negative modifier cubes) to reshape the latch tolerances and clearances. Recommended Print Settings Because this latch sits directly on the BIQU Panda Breath chamber heater/filter unit inside an enclosed printer, standard PLA will soften and warp over time. Material: ASA or ABS (strongly recommended to withstand heated chamber temperatures; PETG may creep if you run high chamber temps) Walls / Perimeters: 1 to 2 walls is enough Infill: 15% to 20% (Gyroid or Grid) is enough, barely used Layer Height: 0.12 mm or smaller Supports: None required