Padel adaptor Quest 3 for a real padel
por Ross Lawless en Thingiverse
This design is made to be screwed onto a padel that you've cut the top off. You tighten the clasp by wrapping an elastic band around it. It's important to print at 30% infill with 6 walls/perimeters. It's also essential that you enable detect thin walls/features in your slicer. After printing...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Ross Lawless.
- Categoría
- Jardín
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
This design is made to be screwed onto a padel that you've cut the top off. You tighten the clasp by wrapping an elastic band around it. It's important to print at 30% infill with 6 walls/perimeters. It's also essential that you enable detect thin walls/features in your slicer. After printing, gently release the hinge by pushing the clasp open. When cutting your padel, cut it approximately 50mm above the hole in the neck of the padel
Descripción original del autor, publicada en Thingiverse.
